@article {238,
	title = {Asphalt volcanoes as a potential source of methane to late Pleistocene coastal waters},
	journal = {Nature Geoscience},
	volume = {3},
	year = {2010},
	note = {id: 1866; Sp. Iss. SI 589XW Times Cited:0 Cited References Count:28; YY},
	pages = {345-348},
	abstract = {Every year, natural petroleum seepage emits 0.2-2 Tg of oil to the ocean(1). Significant oil seepage can build large underwater mounds, consisting of tar deposits with morphologies similar to volcanic lava flows, known as asphalt volcanoes(2,3). Such events are typically accompanied by large fluxes of the greenhouse gas methane(4,5). Marine sediments from the Santa Barbara basin, California, contain a record of elevated methane concentrations(6), anoxia and tar deposition(7) during the Pleistocene epoch that had been attributed to dissolution of methane hydrates. However, the region is known to have exhibited oil seepage in the past(7). Here, we document the discovery of seven extinct asphalt volcanoes off the coast of southern California. The morphology of the deposits and geochemistry of samples taken from the two largest structures supports their classification as asphalt volcanoes, derived from a common source. We estimate that the two structures resulted from seepage of 0.07-0.4 Tg of oil, accompanied by the emission of 0.35-1.8 Tg of methane. Radiocarbon dating of carbonate deposits entrained with the asphalt indicates formation of the volcanoes between 44 and 31 kyr ago. The timing and volume of erupted hydrocarbons from the asphalt structures can explain some or all of the documented methane release and tar accumulation in the Santa Barbara basin during the Pleistocene.},
	issn = {1752-0894},
	doi = {10.1038/Ngeo848},
	author = {Valentine, D. L. and Reddy, C. M. and Farwell, C. and Hill, T. M. and Pizarro, O. and Yoerger, D. R. and Camilli, R. and Nelson, R. K. and Peacock, E. E. and Bagby, S. C. and Clarke, B. A. and Roman, C. N. and Soloway, M.}
}
@article {250,
	title = {Molecular and Isotopic Analysis of Motor Oil from a Biodiesel-Driven Vehicle},
	journal = {Energy \& Fuels},
	volume = {24},
	year = {2010},
	note = {id: 816; 555MH Times Cited:0 Cited References Count:63; YY},
	pages = {1037-1042},
	abstract = {Biodiesel, a mixture of fatty acid methyl esters (FAMEs), is increasingly recognized as a renewable fuel. While some environmental impacts of biodiesel usage have been investigated, accumulation of organic compounds in motor oil, which can subsequently leak onto roads, has not been studied. Because studies have shown that toxic polycyclic aromatic hydrocarbons (PAHs) accumulate in the motor oil of engines fueled with fossil diesel or gasoline, the objective of this study was to determine if this also occurs for engines fueled with biodiesel. Here, we sampled and analyzed motor oil of a biodiesel-powerd 2005 Volkswagen Passat Wagon over 3240 km for personal-use driving. Using gas chromatography with flame ionization detection (GC-FID), we found a total of 0.5\% FAMEs in the motor oil after 3240 km. We also used gas chromatography-mass spectrometry and comprehensive two-dimensional gas chromatography and did not detect PAHs or other organic compounds not present in the initial motor oil. Using natural radiocarbon analysis, a powerful technique capable of detecting biodiesel-derived carbon that would be otherwise undetectable by gas chromatography, we found a total of 0.68\% biodiesel-derived carbon after 3240 km. This is similar to the amount of FAMEs found in these samples with GC-FID, indicating that the primary source of biodiesel-derived carbon in the motor oil is FAMEs (and not PAHs or other carbonaceous species). This result suggests that used motor oil of biodiesel vehicles can be less toxic based on PAH content than vehicles fueled with fossil diesel or gasoline.},
	issn = {0887-0624},
	doi = {10.1021/Ef9011388},
	author = {Peacock, E. E. and Arey, J. S. and DeMello, J. A. and McNichol, A. P. and Nelson, R. K. and Reddy, C. M.}
}
@article {400,
	title = {Determination of biodiesel blending percentages using natural abundance radiocarbon analysis: Testing the accuracy of retail biodiesel blends},
	journal = {Environmental Science \& Technology},
	volume = {42},
	year = {2008},
	note = {id: 1864; 281JN Times Cited:3 Cited References Count:39; YY},
	pages = {2476-2482},
	abstract = {Blends of biodiesel and petrodiesel are being used increasingly worldwide. Due to several factors, inaccurate blending of these two mixtures can occur. To test the accuracy of biodiesel blending, we developed and validated a radiocarbon-based method and then analyzed a variety of retail biodiesel blends. Error propagation analysis demonstrated that this method calculates absolute blend content with +/- 1\% accuracy, even when real-world variability in the component biodiesel and petrodiesel sources is taken into account. We independently confirmed this accuracy using known endmembers and prepared mixtures. This is the only published method that directly quantifies the carbon of recent biological origin in biodiesel blends. Consequently, it robustly handles realistic chemical variability in biological source materials and provides unequivocal apportionment of renewable versus nonrenewable carbon in a sample fuel blend. Analysis of retail biodiesel blends acquired in 2006 in the United States revealed that inaccurate blending happens frequently. Only one out of ten retail samples passed the specifications that the United States Department of Defense requires for blends that are 20\% biodiesel (v/v; referred to as B20).},
	issn = {0013-936X},
	doi = {10.1021/Es071814j},
	author = {Reddy, C. M. and DeMello, J. A. and Carmichael, C. A. and Peacock, E. E. and Xu, L. and Arey, J. S.}
}
